Recalls: Audi B9 S4
Overview
Manufacturers, or importers, issue recalls for defects or faults which have the potential to cause injury. Generally, manufacturers will inform the original buyers if their vehicle is subject to a recall and of the steps required to remedy the defect or fault. Please note that the recalls below (if any) are for Australian-delivered vehicles only. Furthermore, the number of recalls should not be taken as an indication of a model’s reliability or its safety more generally.
Recalls: Audi B9 S4
2019 model year Audi B9 S4: shock absorber failure
In June 2019, recall campaign 40O6 was issued for Audi B9 S4 vehicles because the shock absorber may fail and cause separation of suspension components. If the vehicle was in motion, the driver may lose control and this would pose a hazard to vehicle occupants and other road users. For the VINs of the recalled vehicles, please see PRA 2019/17595.
2018-21 Audi B9 S4: seatbelt warning may operate occasionally
In July 2021, recall campaign 90P5 was issued for 2018-21 Audi B9 S4 vehicles. The seatbelt warning (acoustic warning tone and visual display) may operate occasionally, rather than continuously, in circumstances such as a seatbelt not fastened or unfastened while the vehicle was moving. If the warning did not sound continuously, a seatbelt may be unbuckled without the driver being informed. In the event of a collision, this condition increased the risk of injury to vehicle occupants. For the VINs of the recalled vehicles, please see REC-001650.
2019-21 Audi B9 S4: rear axle nuts could break and cause loss of control
In September 2021, recall campaign 42L1 was issued for 2019-21 Audi B9 S4 vehicles. Some nuts fitted to the rear axle assembly did not meet manufacturing specifications and could therefore break. A broken nut may lead to increased movement between the wishbone and hub carrier, and a change in the wheel alignment on the rear axle. These conditions could cause sudden and uncontrollable movement of the rear axle, thereby increasing the risk of injury and death to vehicle occupants and other road users. For the VINs of the recalled vehicles, please see REC-001665.
2019-21 Audi B9 S4: misalignment of rear axle from previous recall
In March 2022, recall campaign 42L5 was issued for 2019-21 Audi B9 S4 vehicles. The previous replacement of the rear axle clamping nuts as part of recall 42L1 may have caused misalignment of the rear axle assembly; this could result in excessive wear to the rear tyres, and may result in a sudden flat tyre and subsequent loss of vehicle control. These circumstances increased the risk of a collision and injury to vehicle occupants and other road users. For the VINs of the recalled vehicles, please see REC-005076.
Problems and faults: Audi B9 S4
Overview
This section identifies potential problems, causes and fixes based on the experiences of owners and repairers, online sources and technical service bulletins. This information is provided solely for reference purposes and AustralianCar.Reviews recommends that only properly qualified persons carry out repairs or modifications. Furthermore, the number of items below should not be taken as an indicator of a model’s reliability or the frequency with which they may occur.
To report a problem or fault to the AustralianCar.Reviews team, please use the Contact Us form. Note that AustralianCar.Reviews does not offer advice on automotive problems or disputes; such enquiries will not receive a reply. For vehicles purchased from dealers after 1 January 2011, please see our Australian Consumer Law fact sheet.
Problems and faults: Audi B9 S4
No troubleshooting information is currently available for the Audi B9 S4.
