Recalls: Renault X84 Megane
Overview
Manufacturers, or importers, issue recalls for defects or faults which have the potential to cause injury. Generally, manufacturers will inform the original buyers if their vehicle is subject to a recall and of the steps required to remedy the defect or fault. Please note that the recalls below (if any) are for Australian-delivered vehicles only. Furthermore, the number of recalls should not be taken as an indication of a model’s reliability or its safety more generally.
Recalls: Renault X84 Megane
Renault X84 Megane: missing brake pedal stop
In May 2006, a recall was issued for Renault X84 Megane vehicles due to a potentially missing brake pedal stop; in extreme circumstances, this could diminish braking efficiency and affect safety (PRA 2006/8518). Vehicles affected by the recall were in the following VIN ranges:
- VF1BM050629511478 to VF1BM050629623776;
- VF1BM0U0620614593 to VF1BM0U0A30620016;
- VF1BM1B0E30620724 to VF1BM1B0H40623691;
- VF1CM050D30617646 to VF1CM050E40623351;
- VF1CM0U0620614594 to VF1CM0U0A30620017; and,
- VF1LM050630620686 to VF1LM0U0A30619546.
Problems and faults: Renault X84 Megane
Overview
This section identifies potential problems, causes and fixes based on the experiences of owners and repairers, online sources and technical service bulletins. This information is provided solely for reference purposes and AustralianCar.Reviews recommends that only properly qualified persons carry out repairs or modifications. Furthermore, the number of items below should not be taken as an indicator of a model’s reliability or the frequency with which they may occur.
To report a problem or fault to the AustralianCar.Reviews team, please use the Contact Us form. Note that AustralianCar.Reviews does not offer advice on automotive problems or disputes; such enquiries will not receive a reply. For vehicles purchased from dealers after 1 January 2011, please see our Australian Consumer Law fact sheet.
Renault X84 Megane: pressure loss in braking system
In 2009, Renault UK issued a ‘non-code action’ for Renault X84 Megane vehicles because of potential pressure loss in the braking system (NCA/2009/015); no further information was provided.
Problems and faults: Renault X84 Megane
- If the Renault X84 Megane’s engine misfires, does not run on all cylinders or runs rough, the ignition coils may need to be replaced – this is a common problem.
- For petrol engines, the engine could cut-out and run rough due to a faulty cam sensor; the sensor could also drain the battery even when the ignition was switched off.
- Uneven rear tyre is partially due to the negative camber of the rear suspension. However, premature tyre wear has also been attributed to 17-inch Continental tyres, with other brands of tyre recommended in their place.
- When driving, the engine rpm may increase, drop to zero and the engine may then cut out – this may be due to a corroded wiring loom and is often accompanied by difficulty starting the vehicle.
- The coil springs – front and rear – were susceptible to breaking.
